This page uses Javascript.
Your browser either doesn't support Javascript or you have it turned off. To see this page as it is meant to appear please use a Javascript enabled browser.
 
Brick and terracotta are durable and forgiving materials. Appropriate sealers
mitigate the absorbency of fired clay. Aggressive cleaning can remove accumulated soil, but professional striping is necessary to remove old coatings and wax.

The best results can be obtained by using the right materials before soil accumulates. The best cleaner is a pH neutral cleaner formulated for cleaning natural stone or a special terracotta cleaner. Stone cleaners are available from many stone retailers. They are highly concentrated, and are actually economical to use.

Dilute 1 or 2 ounces of the stone cleaner in a 3 to 5 gallon bucket of clean, warm water. Fill another bucket with more clean, warm water. Apply the cleaner with the mop, and then rinse the dirty mop in the second bucket of rinse water. Vacuum up the dirty water or squeeze the mop dry and mop up the dirty water on the floor. Rinse the mop again.

Empty both buckets; clean them well and rinse the mop. Refill both buckets with clean, warm water. Apply the rinse water to the floor. Vacuum up the rinse water or squeeze the mop dry and mop up the rinse water on the floor.

A stronger solution of stone cleaners can loosen small areas of stubborn dirt. Apply with a sponge and agitate the soil with a soft natural brush but do not allow the cleaner to deeply penetrate the terracotta. Wipe up thoroughly and rinse well.

Stain removal is not guaranteed. First determine whether the stain is water based (wine, etc.) or oil based (salad dressing). Some stone retailers sell poultices that can usually absorb the stain, until it is virtually undetectable. Follow the directions exactly. Usually the poultice is slightly moistened with a suitable liquid, and then spread over the stain. The poultice is usually covered with plastic wrap so that it remains moist. After the specified time has past, remove the plastic cover and wipe up the poultice. Clean with stone cleaner. If two applications of the poultice do not lighten the stain, it has penetrated the terracotta too deeply. Consult with a professional; professional cleaners may lighten some stains; however, oily stains in brick and terracotta are often permanent.
customercare@hartzstone.com  privacy  legal
2006-08 HartzStone, LLC All rights reserved.